Diagnostics and repair
Experienced technicians look the appliance over before they suggest any work. OEM parts can be ordered, and the correct part is matched to your model.
The care journal
Something quit working? Begin with the checks the manual permits, and learn when a technician should step in.

Frost in a Kenmore 795 bottom-freezer comes mostly from warm, humid air getting in. The guides name frequent or long door openings, a door that does not close properly, humid weather and unwrapped food. Fix the door, wrap the food, then wait 24 hours.

After a power cut, a Kenmore dryer may show PF: press and hold START to restart (press POWER first on some models). If the drum turns but there is no heat, check that both household breakers or fuses are on; an electric dryer uses two. L2 points to the home power supply.

If your Kenmore dryer smells burnt or runs very hot, stop it and unplug it. The guides name only a few harmless odors, a new heating element and nearby paint fumes. Otherwise check the lint screen, the vent and the hood for blockage, and never dry items that carry oil.

A Loc message, a flashing or steady DOOR LOCKED light and a triple beep on each key press mean the oven lockout is on, not that the panel has failed.
Read the full sequence
On the Kenmore 790 ranges, a dead-looking oven panel usually means one of four things: the oven lockout is on, the clock was never set, an F or E code stopped the control, or power is missing. Cancel the lockout first; a code needs a restart.

A Kenmore oven door that will not open is almost always the self-clean lock, which holds until the oven has cooled. Do not force it. For a door that is misaligned or has been removed, the guide gives hinge-lock steps, and the glass needs care.

On a Kenmore 790 gas cooktop, a flame that is too high, uneven or orange has a short list of causes in the guide: a knob set high, a burner cap sitting wrong, clogged ports, moisture after cleaning or an incorrect LP conversion. Check the cap and ports first.
On the 405.7608# gas range, Er followed by a number or letter is a function error code. Press Cancel/Off, let the oven cool for an hour, and use it again. If Er repeats, leave the oven dark for 30 seconds or longer, then restore it.
The 405.7608# guide prints ErrF in the same troubleshooting row as Er, as a function error code. Press Cancel/Off, wait one hour, then use the oven again. If ErrF returns, cut all power to the oven for at least 30 seconds.
Experienced technicians look the appliance over before they suggest any work. OEM parts can be ordered, and the correct part is matched to your model.
Covered repairs under a Kenmore manufacturer warranty are handled through Kenmore. We stand behind our own work with a workmanship warranty.
Check power, the breaker, the door or lid and whether the machine is level. Then read the page for your symptom. When none of that works, book a visit and tell us what you tried.
Not usually. Check the lid or door first, then the water supply. If a code appears, photograph it and look it up by model family. Book a visit if it returns.
No. Shut the water, unplug the unit and dry the floor. Leaks reach wiring and flooring quickly, so leave it off until a technician has looked.
Yes. Unplug the dryer and do not run it again until it has been inspected. Lint buildup and a blocked vent are among the things the guides warn about.
Code, symptom, part or service
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.