What it means
The 405.7608# guide prints ErrF in the same troubleshooting row as Er, as a function error code. Press Cancel/Off, wait one hour, then use the oven again. If ErrF returns, cut all power to the oven for at least 30 seconds.
Kenmore range ErrF / Function error
The 405.7608# guide prints ErrF in the same troubleshooting row as Er, as a function error code. Press Cancel/Off, wait one hour, then use the oven again. If ErrF returns, cut all power to the oven for at least 30 seconds.
Also shown as ErrF
The 405.7608# guide prints ErrF in the same troubleshooting row as Er, as a function error code. Press Cancel/Off, wait one hour, then use the oven again. If ErrF returns, cut all power to the oven for at least 30 seconds.
Press the Cancel/Off pad.
ErrF returns even after the cooldown and the power disconnect.
Your checklist / stored on this device

Press the Cancel/Off pad. You should be back at the clock.

Wait the full hour before restarting the oven.

If ErrF reappears, remove all power from the oven for half a minute at least, then switch it on again.

Burner ignition failure has a row of its own. Make sure the gas shutoff valves read Open.
If ErrF repeats again after the power reset, book a technician.
Give us the model and the checks you have already done, and open your request from here.
Book a visit
Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.
The table's wording is that ErrF appears on the display, and it shares a row with the Er-plus-character message. The cause is a function error code.
Read the supporting manualIgnition failure or flameout has a different row in the guide, with its own shutoff valve advice. Treat them as separate unless your range shows both.
Read the supporting manualNot for the first appearance. The guide's order is Cancel/Off, one hour, power disconnect, then call if it repeats.
Read the supporting manualManufacturer document
Kenmore
No edition printed / PDF p.27 (Trouble Shooting Guide)
From the same p. 27 table of the 405.7608# guide. The 790 guide 1403611L gives a five-minute power-off instead; the two differ.
The two share one row, so the steps match. It does not rank them.
The guide prints both forms in the same table row. Treat both as a function error code and note which one your display shows.
Not for a first appearance. The guide's order is Cancel/Off, an hour of cooling, a power disconnect of at least 30 seconds, then a call if the code repeats.
Leave the house and phone the gas supplier from a neighbor's, as the safety page directs. Do not use switches or the range.
The gas range 405.7608#. Other Kenmore ranges print F codes instead, and those have their own pages.
Code, symptom, part or service
Hot appears on the 405.7608# gas range display when the oven is above 100 degrees F. A steam clean cannot start until the oven cools. It is a message, not an error.
On the Kenmore 790 ranges, a dead-looking oven panel usually means one of four things: the oven lockout is on, the clock was never set, an F or E code stopped the control, or power is missing. Cancel the lockout first; a code needs a restart.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.