We listen first
Your model, what you noticed and any code on the display set up the visit. The technician identifies the cause by inspecting the appliance, not by guessing from a code.
About Kenmore Appliance Support
We are an independent repair service for Kenmore appliances in nine US metro areas. We help you read what your appliance is signaling, and send a technician when it needs one.

Your model, what you noticed and any code on the display set up the visit. The technician identifies the cause by inspecting the appliance, not by guessing from a code.
Our code, problem and care pages are based on Kenmore’s own manuals and give page references, so you can compare our wording with your model.
What happens after you book.
Model number first.

Type in the number from the label, along with what the appliance does. A photo of the label works too.

The technician reads the code against your model, finds the failed part and gives you a cost before starting.

The new part goes in, the cycle is tested, and you hear what was done.
After the technician has examined the appliance you are given the cost of the repair, and you decide whether to go ahead.
Covered repairs under a Kenmore manufacturer warranty are handled through Kenmore. We stand behind our own work with a workmanship warranty.
Kenmore Appliance Support is an independent repair company for Kenmore owners in nine metros. The same team writes the pages from Kenmore's Use & Care guides and books technicians into homes.
No. We are an independent company with no tie to Kenmore or the companies that license the name. The name only tells you which appliances we repair.
Book online or phone. Tell us the appliance, the model number, your address and what changed, and photograph any code. After that we get in touch to set the visit time. Visits run 8 am to 8 pm, seven days a week.
No. If your unit is under the manufacturer's warranty, the manufacturer handles that repair. We can only help with repairs booked with us.
Code, symptom, part or service
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.