Diagnostics and repair
Experienced technicians look the appliance over before they suggest any work. OEM parts can be ordered, and the correct part is matched to your model.
The care journal
What the code on your display is saying, how neighboring codes differ and what to try first.

Find the characters on the display and your washer's number before the dot in the model number: an identical message can mean different things on a Calypso and a 796.
Read the full sequence
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.

Violent shaking on a Kenmore washer comes down to a lopsided load, feet that are not all touching, shipping bolts left in, or a floor that flexes. Pause, spread the load, check the feet and the bolts, then book us if the shaking persists.

On a 796 front-load washer, buttons that do nothing often mean the Control Lock is on and CL is flashing in the display. Hold the CHIME button for three seconds to switch it off. If the washer is simply dead, check the plug, the breaker and the door or lid.
PF means power failure. On a Calypso it flashes: press START to continue the cycle from the moment power was lost, or STOP/CANCEL to clear and cancel. On 796 front-loaders PF shows the next time you turn the washer on, and selecting any cycle clears it.
The Calypso shows Er for a Processor Reset Error: the cycle information was not stored during a power failure. Clear the display with STOP/CANCEL, then set the cycle up again from scratch.
CA is the Calypso washer's current limit message. The guide's question is whether the machine is overloaded, and its remedy is one key press that wipes the display. Take some items out before you start again. A 796 top-load uses CL for something else, so match the code to your model prefix.
Sd is the suds message: the control sensed more foam than it should. On 110 front-loaders the display shows SUD and a suds routine starts on its own. On 796 front-loaders it shows Sud and adds a Suds Reducing cycle of about two hours. Use less detergent next time.
Experienced technicians look the appliance over before they suggest any work. OEM parts can be ordered, and the correct part is matched to your model.
Covered repairs under a Kenmore manufacturer warranty are handled through Kenmore. We stand behind our own work with a workmanship warranty.
Kenmore washers come from different makers and years. The guides for the 110 and the 796 families print different meanings for letters like CL and tE, so we name the family on every page.
The Kenmore guides we read print no meaning for it. We list what they do say, the safe checks and when to book. We never fill that gap with a guess.
No. Those are made under the Curtis International license and come with new guides we have not read. Our pages describe the older 110 and 796 families.
Photograph it first. A reset can clear a one-time message, yet the picture still helps the technician if that code was an early sign of a genuine problem.
Code, symptom, part or service
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.