Kenmore washer Sd / Suds

Kenmore washer
error Sd

Washer / display referenceSd

Sd is the suds message: the control sensed more foam than it should. On 110 front-loaders the display shows SUD and a suds routine starts on its own. On 796 front-loaders it shows Sud and adds a Suds Reducing cycle of about two hours. Use less detergent next time.

Also shown as Sd

Last reviewed

Washer / display referenceSd
Meaning
Sd is the suds message: the control sensed more foam than it should. On 110 front-loaders the display shows SUD and a suds routine starts on its own. On 796 front-loaders it shows Sud and adds a Suds Reducing cycle of about two hours. Use less detergent next time.
Who handles it
Owner checks first, then a technician
Related codes
Source
Use & Care Guide, Kenmore front-load washers 110.4708/4709

What Kenmore washer Sd means.

What it means

Sd is the suds message: the control sensed more foam than it should. On 110 front-loaders the display shows SUD and a suds routine starts on its own. On 796 front-loaders it shows Sud and adds a Suds Reducing cycle of about two hours. Use less detergent next time.

What you can safely check

SUD is displayed through the rinse and again at the finish, while the washer works the foam out.

When to call a technician

The suds message keeps coming back even with the recommended dose of detergent.

Your checklist / stored on this device

Safe checks, in order.

0 of 5 checks done
  1. Kenmore washer Sd: Washers in a thoughtfully designed home
    Illustration. Follow your model’s instructions.
    Before you begin

    Let a SUD routine run on a 110 front-load

    SUD is displayed through the rinse and again at the finish, while the washer works the foam out. Do not interrupt it.

  2. A worn rating label on the rim of an older top-load washer
    Illustration. Follow your model’s instructions.
    Check 2

    796 front-load: cycle the power

    To remove suds, turn it off and on, then run the Rinse & Spin cycle.

  3. Over the shoulder of a technician in a navy shirt holding a tablet with a blank checklist, a white washer behind him.
    Illustration. Follow your model’s instructions.
    Check 3

    Measure the detergent

    Do not add more than the maker's recommended amount. Use only HE detergent in these washers.

  4. A technician with a washer drain pump in hand
    Illustration. Follow your model’s instructions.
    Check 4

    Wipe any suds from the door seal

    Residue left on the gasket can drip. This is our own housekeeping tip.

  5. Illustration. Follow your model’s instructions.
    Check 5

    Book a visit if suds return after a measured dose

    Suds codes that come back with the right amount of detergent need a look.

Still showing Sd?

Give us the model and the checks you have already done, and open your request from here.

Book a visit

Fill and the water level.

Conceptual Washer sectionInlet valveTubLevel sensorDrain pump1234
  1. 2Tub

Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.

A little more context.

What does Sd mean?

The record covers three printings: SUD on 110 front-loaders, Sud on 796 front-loaders, and SL on the Calypso. All describe the washer detecting too many suds.

Read the supporting manual

Why does a 796 washer add two hours?

The guide says that when too many suds are detected the washer displays the code and adds a Suds Reducing cycle of about two hours. If suds appear during spinning, it stops to help prevent leaking.

Read the supporting manual

How is Sd different from OE?

Sd is about foam. OE is slow draining, shown as OE on 796 washers and Ld on Calypsos. Foam can slow drainage, so the two can seem alike.

Read the supporting manual

The manual behind the message.

Manufacturer document

Use & Care Guide, Kenmore front-load washers 110.4708/4709

Kenmore (guide as published by Sears / Transform SR Brands)

Doc L0809415 / P/N 8183014B / PDF p.22 ("SUD" Suds Routine)

Manufacturer document

Use & Care Guide, Kenmore front-load washers 110.4292/4492/4493

Kenmore (guide as published by Sears / Transform SR Brands)

Doc L0409348 / PDF p.19 ("SUD" Suds Routine)

Manufacturer document

Use & Care Guide, Kenmore front-load washers 796.4136/4146/4156

Kenmore (guide as published by Sears / Transform SR Brands)

Doc 1909134L / P/N MFL68005592 (Transform SR Brands) / PDF p.46 (Sud graphic)

Manufacturer document

Use & Care Guide, Kenmore Calypso washers 110.2206/2408/2506/2508

Kenmore (guide as published by Sears / Transform SR Brands)

Doc L0412465 / P/N 8543703 (Sears, Roebuck and Co.) / PDF p.18 ("SL" Suds Lock)

110 front-loaders (4708, 4709, 4292, 4492, 4493), 796 front-loaders (4136, 4146, 4156) and the Calypso, pulled together from four guides.

Here to help

Good questions.
Clear answers.

Talk to our team
What detergent should I use?

The 110 front-load guide says use only HE (High Efficiency) detergents. The 796 guide says not to exceed the manufacturer's recommended amount.

How long does the 796 Suds Reducing cycle take?

The guide says it adds about two hours to the cycle time.

What do I do on a 796 to clear the suds?

Power the washer down and up, then start Rinse & Spin.

What does SUD on a 110 front-load mean?

A suds routine started automatically. The SUD display tells you the routine ran; it appears through the rinse and at the close of the cycle.

Why would the washer stop during the spin?

If too many suds are detected during spinning, the 796 front-load stops to help prevent leaking.

Let’s take care of it.

Still going after all these years.
Let’s keep it that way.