Inside the appliance
Washer water inlet valve. In plain English.
The washer water inlet valve is where hot and cold water enter a Kenmore washer, and its filter screens trap debris. The 796 guides print FE when a defective valve lets the tub overfill. Turn both faucets off, cut power and book a visit.

Where it fits.
Washer water inlet valve in the appliance
Where the hoses attach, with the filter screens seated in those hose ports.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Washer water inlet valve concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Turn both faucets off
For FE the guides begin by cutting the water, so nothing more reaches the tub.
- 2
Unplug the washer
Then cut power, using the breaker when the floor is wet.
- 3
Know what the screens protect
The front-load guide says the screens protect the delicate valve parts. Running without them can leave a valve unable to open and cause flooding.
- 4
Keep supply pressure in range
The guide asks for house supply of 20 to 120 psi, with a pressure reducing valve installed above that.
- 5
Look at the hose ends
The guide cautions against cross-threading the fittings and says to check the hoses periodically for cracks, leaks and wear.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit when FE shows, or when water keeps coming in after the cycle ends.
Book a technician when a hose connection leaks after it is tightened by hand.
Arrange a diagnosticSources and model boundaries.
These sources back up the Washer water inlet valve guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore front-load washers 796.4136/4146/4156
- Use & Care Guide, Kenmore top-load washer 796.2927
Go by the instructions for your exact model. Check how we research these pages.
What does FE mean on a Kenmore washer?
The 796 guides explain FE as an overfilled tub caused by a bad water valve. Their response: faucets off, plug out, service call.
What are the inlet valve screens for?
They protect the delicate valve parts from particles in the water. The front-load guide warns that removing them could keep a valve from opening and cause flooding.
How much supply pressure is right?
The 796 front-load guide specifies 20 to 120 psi, and a pressure reducing valve if the supply runs higher.
Is FE urgent?
Yes, since water may keep entering the tub. Cut both faucets first, then disconnect power and book a visit.
Code, symptom, part or service
Link the message to what comes next.
FE
FE means the water level is too high, and the 796 guides tie it to a faulty water valve. Turn off both faucets, unplug and call for service. It is an urgent one: do not leave water flowing into the tub.
Kenmore washer not spinning
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Washer repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.


