Inside the appliance
Washer water level sensor. In plain English.
A 796 Kenmore washer relies on its water level sensor to judge the fill. When the reading goes wrong the display shows PE, and the guides leave owners nothing to repair: shut both faucets, pull the plug and book a technician. A tub that looks nearly empty is usually normal, since these models use very little water.

Where it fits.
Washer water level sensor in the appliance
Inside the cabinet. The guides give no sensor position, so none is stated.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Washer water level sensor concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Shut both faucets
Both 796 guides begin with the supply. Turn the hot and cold taps off so nothing more runs into the tub.
- 2
Unplug the washer
Remove power, using the breaker when the floor is wet.
- 3
Leave the tub parts alone
No owner adjustment is listed for the sensor, so keep out of the cabinet hoses and fittings.
- 4
Do not mistake low water for a problem
Per the front-load guide, fill depth follows the load, and depth can be far below what you expect. That is normal operation.
- 5
Drain a too-high tub the guide's way
On the front-load model, press POWER, then SPIN SPEED without choosing a cycle, then START/PAUSE to drain it.
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician as soon as PE appears on a 796 washer.
Book a visit when the tub fills far beyond the load, with FE on the display.
Arrange a diagnosticSources and model boundaries.
These sources back up the Washer water level sensor guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore front-load washers 796.4136/4146/4156
- Use & Care Guide, Kenmore top-load washer 796.2927
Go by the instructions for your exact model. Check how we research these pages.
What does PE mean on a Kenmore washer?
Both 796 guides print PE for a level sensor that is misbehaving. The listed response is faucets off, plug out, then a service call.
Why is there so little water in my Kenmore front-loader?
Per the 796 front-load guide, the washer picks its fill for the load, so a shallow tub is expected. It says washing results are not affected.
How do I drain a front-load washer with too much water?
Press POWER, then SPIN SPEED without selecting a cycle, then START/PAUSE. The guide gives these steps for a tub the door will not release.
Is there an owner test for the sensor?
None is printed. The only owner steps are the faucets and power.
Code, symptom, part or service
Link the message to what comes next.
PE
PE means the water level sensor is not working correctly on 796 Kenmore washers. Both guides ask you to turn off the faucets, unplug and call. Owners have nothing to repair here, so book a technician.
Kenmore washer not spinning
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Washer repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

