Inside the appliance
Range oven door lock. In plain English.
Kenmore’s Elite 790 ranges lock the oven door with a motor-driven latch. The guide says it locks automatically when you turn on oven lockout (“Loc” shows) and for Self Clean, and warns you not to open or close the door while the latch is moving.

Where it fits.
Range oven door lock in the appliance
The guide names a motor-driven door latch and shows the door-locking display (Figure 18) but does not draw the latch. It is not a part to open or adjust.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Range oven door lock concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore range controls not responding
On the Kenmore 790 ranges, a dead-looking oven panel usually means one of four things: the oven lockout is on, the clock was never set, an F or E code stopped the control, or power is missing. Cancel the lockout first; a code needs a restart.

Kenmore range oven door problems
A Kenmore oven door that will not open is almost always the self-clean lock, which holds until the oven has cooled. Do not force it. For a door that is misaligned or has been removed, the guide gives hinge-lock steps, and the glass needs care.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Wait for it
Hold Oven Lockout for 3 seconds and the display shows door Loc while the latch locks. The guide says to allow about 15 seconds, then Loc stays on once locked.
- 2
Unlock the same way
To cancel, hold Oven Lockout for 3 seconds again. Allow about 15 seconds until Loc leaves the display before you open the door.
- 3
Don’t force the door
The guide warns that opening or closing the door while door Loc shows can damage the latch mechanism.
- 4
Handle error codes
If the control beeps and shows an F or E code, press STOP to clear it, try bake or broil, then if it repeats turn off power for 5 minutes and repower.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if Loc stays on after canceling lockout and waiting, or the door won’t latch for Self Clean.
Book a visit if an F or E code returns after a 5-minute power-off.
If you smell gas, do not light anything or touch a switch; use a neighbor’s phone to call your gas supplier, and call the fire department if you can’t reach them.
Arrange a diagnosticSources and model boundaries.
These sources back up the Range oven door lock guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Elite slide-in gas range 790.4260/4261
- Use & Care Guide, Kenmore Elite dual-fuel slide-in range 790.4103/4104
Go by the instructions for your exact model. Check how we research these pages.
What does Loc mean on my Kenmore oven?
On the Elite 790.4260, Loc means the oven door is locked, either from oven lockout or Self Clean. door Loc shows while the latch moves.
How long does the door take to lock?
The guide says to allow about 15 seconds for the door to completely lock, and the same to unlock it. Don’t open or close it during that time.
What if an F code shows?
The 790.4260 guide says press STOP, try bake or broil, and if the code repeats turn the power off for 5 minutes, then repower. It doesn’t decode the number.
Does the lock fail often?
Our sources give no failure rates. The guide only describes how it locks and unlocks, so ask a technician if the door sticks.
Code, symptom, part or service
Link the message to what comes next.
Kenmore range controls not responding
On the Kenmore 790 ranges, a dead-looking oven panel usually means one of four things: the oven lockout is on, the clock was never set, an F or E code stopped the control, or power is missing. Cancel the lockout first; a code needs a restart.
Range repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

