Using your appliance

Loading a Kenmore washer: how to keep the spin from stalling

A Kenmore washer stops its spin when the load sits unevenly. Load loosely, mix large and small items, never wash one heavy item alone, and keep the drum from being packed tight. If the washer pauses with an imbalance message, redistribute the load and restart.

Laundry basket of mixed towels and shirts on the floor beside an open front-load washer, one towel hanging over the edge.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Large items should be no more than half the load, and the drum should not be tightly packed. 1
  • A single heavy item is a classic cause of imbalance; add one or two similar items. 12
  • The washer makes several tries at rebalancing before it stops and shows its message. 12
  • On a 796 front-loader the door may stay locked if you pause a hot cycle. 1
  • Where the guide is silent, we say so rather than guess. 1

Why does my Kenmore washer stop before the spin finishes?#

Most of the time the washer has sensed an uneven load and stopped to fix it. Both the 796 front-load and top-load guides describe an imbalance system that makes several tries at the spin, then stops and shows a message if it cannot balance. 12

That is a protective step, not a breakdown. A drum that spins fast with a lump of wet laundry on one side shakes the whole cabinet, so the control gives up before it does damage.

The fix is almost always in the load. This guide covers how to load each Kenmore family, what the washer does when it senses a bad balance, and when to stop troubleshooting and book a visit.

How should I load a Kenmore front-load washer?#

On a 796 front-loader, mix large and small items, put the large ones in first, and keep them under half the load. Leave the drum loose so the door closes easily. Do not press items down while you stack them. 1

The guide lists the rules in this order. Work through them each time.

  1. 1

    Empty every pocket#

    Clips, pens, coins and keys can damage the washer and the clothes. The same page warns about keys and coins turning up in the drain filter. 1

  2. 2

    Close zippers and hooks#

    Closed zippers, hooks and drawstrings are less likely to snag or tangle on other clothes. 1

  3. 3

    Load the large items first#

    Large pieces go in first. They should not be more than half of the total load. Add smaller items around them. 1

  4. 4

    Skip single items#

    The guide says not to wash single items, to prevent an out-of-balance load. Add one or two similar items instead. 1

  5. 5

    Wash blankets and comforters on their own#

    The guide says a blanket, comforter or bedspread should be washed individually. 1

  6. 6

    Check the drum and the door#

    Load clothes loosely and do not overfill the drum. The door should close easily, with nothing caught in the gasket. 1

Front-load washer with its door open and a loose mixed load of towels and shirts filling most of the drum.
Loose, mixed and not packed: the drum should close easily. 1

How full is too full?#

The washer can be fully loaded, but the drum should not be tightly packed and the door should close easily. The guide ties overloading to wrinkled clothes and to items caught between the door and the seal. 1

That second point matters. The guide says overloading can pinch items between the door and the seal and damage both, so it tells you to check under the seal when you unload. 1 A forgotten sock behind the seal also shows up later as a musty smell.

Two things the guide says never to wash or spin: waterproof items such as rain coats, and sleeping bags. 1

How do I load a Kenmore top-load washer?#

Drop clothes in without wrapping them around anything. The Calypso guide puts small garments in first, keeps small items off the top, and says not to load above the level marked in the basket. 3

The same page suggests mesh bags for underwire bras, items with strings and small things such as socks, which keeps them from tangling into one hard knot. 3

On the 796 top-load, bulky pieces need care. The guide says a pillow or blanket hanging over the tub can leak water and tells you to use the BULKY/BEDDING cycle for large items and to lay them into the tub. 2

Open top-load washer with clothes spread around the basket and two towels draped over the rim, lid raised.
Clothes spread around the basket, nothing draped over the rim. 23

Like the front-loader, the 796 top-load washer can be fully loaded, but the tub should not be tightly packed and the lid should close easily. 2

What does the washer do when a load is out of balance?#

The washer stops the spin, redistributes the load and tries again. Both 796 washers say they make several attempts. If an imbalance is still detected, the washer stops and shows its error message. The 110 Calypso shows "ob". 123

The families differ in what you see and hear.

FamilyWhat it doesWhat the guide says to do
796 front-loadSeveral spin attempts, then stops with a message 1Pause, redistribute after the door unlocks, add one or two similar items to a small load 1
796 top-loadMay stop and refill to redistribute the load; the same message if it fails 2Rearrange the items; add one or two similar items to a small load 2
110 Calypso top-loadShows "ob" (Off Balance) 3Redistribute the load, shut the lid, then press START 3

The code pages name the messages in full: see UE for the 796 washers, and the CA and CL page for the Calypso current-limit message that the guide ties to an overloaded washer. 3

Is the water sloshing or thumping a problem?#

No. The 796 top-load guide says a liquid ring on top of the tub helps balance it during spin and can be heard sloshing when the tub stops. It also lists a refill sound as the washer rebalancing a load. 2

A heavy load may thump on the 796 front-loader. The guide calls that normal, and says that if it continues, the washer is probably out of balance. 1

How do I rebalance a load that stopped the washer?#

Pause the cycle, wait for the door or lid to release, spread the laundry out and restart. If the load was too small, add one or two similar items. 12

  1. 1

    Pause or stop the cycle#

    Press the pause button on the 796, or STOP/CANCEL on the Calypso, to stop the drum. 13

  2. 2

    Wait for the door to unlock#

    On a 796 front-loader the door will not unlock while the drum interior is very hot, for example if you paused a hot wash. Wait until the DOOR LOCK light goes off. 1

  3. 3

    Spread the load out#

    Pull the laundry apart and spread it around the drum or basket. Take out any one heavy piece that is dragging the rest to one side. 12

  4. 4

    Add a similar item to a small load#

    If there are only one or two pieces, add one or two similar pieces. 12

  5. 5

    Close up and restart#

    Shut the door or lid and start the cycle again. On the Calypso you must press START yourself once the lid is down. 3

If the water level is too high to open the door, the 796 front-load guide drains it for you: press POWER, then press SPIN SPEED without selecting a cycle. 1

Does a longer cycle mean the washer is stuck?#

Not necessarily. The 796 front-load guide says the washer adjusts the cycle time for the load, the water pressure and the heating time, and that the time in the display is only an estimate. The time can even stop for a while while it balances the load. 1

So a cycle that runs past its time is not a breakdown on its own. See the display messages guide for the other messages that look alarming but are not.

When is it not the load?#

If a loose, evenly spread load still stops the spin, the cause is probably not the way you loaded it. Check the display, then book a visit. 12

Close view of a white washer control panel with a dial, a small softly lit display and a row of five plain buttons.
Write down the characters on the display before you call. 13

Two examples from the guides: LE is a motor message, and the guide says to let the washer stand for 30 minutes before you restart the cycle. 1 If the washer will not drain, the guide points you to the drain hose, the drain pump filter and the maximum drain height before anything else. 1

The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. What we repair on these machines is on the washer service page, and the problem page to read next is a Kenmore washer that will not spin.

Flashlight glow on a small blank rating label on the frame beside an open dryer door hinge, the drum visible at right.
The number before the dot tells us which Kenmore family you have.

Sources#

  1. Use & Care Guide, Kenmore front-load washers 796.4136/4146/4156Kenmore / Transform SR Brands · Document 1909134L (part MFL68005592), no date printed · pp. 24 (Loading the Washer), 27 (Time and Status Display), 44-46 (Before Calling for Service)
  2. Use & Care Guide, Kenmore top-load washer 796.2927Kenmore / Sears Brands · Document 1007244L (part MFL42065471), no date printed · pp. 26-28 (Normal Sounds, Before Calling for Service)
  3. Use & Care Guide, Kenmore Calypso top-load washers 110.2206Kenmore / Sears Roebuck · Document L0412465 (part 8543703), no date printed · pp. 11 (Washer Use), 16 (Loading), 18 (Troubleshooting)
  4. Use & Care Guide, Kenmore front-load washers 110.4708/4709Kenmore / Sears Roebuck · Document L0809415 (part 8183014B), no date printed · p. 22 (Troubleshooting, F22)

Here to help

Good questions.
Clear answers.

Talk to our team
Can I wash one heavy item by itself in my Kenmore washer?

It is the usual cause of a stalled spin. The 796 front-load guide says not to wash single items and to add one or two similar ones. A blanket or comforter is the exception: the guide says to wash those individually. See source 1, page 24.

Is a thumping sound during the spin a problem?

Not by itself. The 796 front-load guide calls thumping from a heavy load normal. If it keeps going, the load is probably out of balance, so pause the cycle and spread the load out once the door unlocks. See source 1, page 44.

Why will my front-load door not open when I pause to rebalance?

The door has a safety lock. If you pause during a hot stage, the drum stays hot and the door stays locked until the DOOR LOCK light goes off on the display. This is normal. See source 1, page 45.

How many times does the washer try to rebalance before it quits?

The 796 guides say several attempts, with no exact number. If it still senses a bad balance, it stops and shows its imbalance message. See source 1, page 46, and source 2, page 28.

Does a bigger load always mean a worse balance?

No. A load that is too small can also upset the balance. The guides give the same fix for both ends: add one or two similar items to a small load, or spread out a big one. See source 1, page 46.

Let’s take care of it.

Still going after all these years.
Let’s keep it that way.