What it means
UE on a 796 Kenmore washer means the wash load is small or lopsided. Add one or two similar items; the washer makes several attempts to restart the spin and shows the code if it still detects an imbalance.
Kenmore washer UE / Balance
UE on a 796 Kenmore washer means the wash load is small or lopsided. Add one or two similar items; the washer makes several attempts to restart the spin and shows the code if it still detects an imbalance.
Also shown as UE
UE on a 796 Kenmore washer means the wash load is small or lopsided. Add one or two similar items; the washer makes several attempts to restart the spin and shows the code if it still detects an imbalance.
Is it one heavy item, a bath mat or a robe?
UE returns with an evenly mixed load.
Your checklist / stored on this device

Is it one heavy item, a bath mat or a robe? Those cause imbalance.

Match them in size and weight.

Untangle sheets and towels.

Run the cycle again after rebalancing.
A washer that is not level shakes more. This is our own tip.
Give us the model and the checks you have already done, and open your request from here.
Book a visit

Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.
The 796 troubleshooting list reads Load is too small and Load is out of balance. It adds that the washer tries several times to restart the spin before it stops and shows the code.
Read the supporting manualIt has an imbalance detection and correction system. If individual heavy articles are loaded, it makes several attempts to restart the spin cycle.
Read the supporting manualThe old uL is not printed in the Kenmore guides here. The guides do not link it to UE.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1909134L / P/N MFL68005592 (Transform SR Brands) / PDF p.46
Manufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1807405L / P/N MFL68005554 / PDF p.31
Manufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1007244L / P/N MFL42065471 / PDF p.28
Tables in the 796 guides 1909134L and 1007244L.
The guide lists load is too small as a cause. Adding one or two similar items helps the washer balance.
It has an imbalance detection and correction system and makes several attempts to restart the spin cycle before stopping.
Individual heavy articles such as a bath mat or bath robe.
The old uL is not printed in any Kenmore guide here, and the guides do not link it to UE.
When UE returns on an evenly mixed load.
Code, symptom, part or service
OE is the 796 Kenmore message for water that drains slowly, or not at all. Inspect the drain hose for kinks and clogs, clean the drain pump filter, and keep the discharge at 96 inches (244 cm) or less above the bottom of the washer. The top-load guide also lists a drain pump that failed.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.