What it means
Ld (Long Drain) is the Calypso's slow-drain message. The guide asks if the drain hose is kinked or clogged and says STOP/CANCEL clears the display. The 110 front-loaders print F21 and F02 for a drain problem instead.
Kenmore washer Ld / Drain
Ld (Long Drain) is the Calypso's slow-drain message. The guide asks if the drain hose is kinked or clogged and says STOP/CANCEL clears the display. The 110 front-loaders print F21 and F02 for a drain problem instead.
Also shown as Ld
Ld (Long Drain) is the Calypso's slow-drain message. The guide asks if the drain hose is kinked or clogged and says STOP/CANCEL clears the display. The 110 front-loaders print F21 and F02 for a drain problem instead.
Check behind the washer for kinks, a hose squeezed against the wall, or a clog.
Ld is back although the hose has been looked at and the display cleared.
Your checklist / stored on this device

Check behind the washer for kinks, a hose squeezed against the wall, or a clog.

Clear the display after checking the hose.

The front-load guides limit the discharge to 96 inches; check yours if the washer sits far from the drain.

In cold garages a drain hose can freeze. The front-load guides mention freezing.

Run a drain and spin to see whether the tub empties.
Give us the model and the checks you have already done, and open your request from here.
Book a visitSimplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.

Component reference
The 796 front-load washer has a drain pump filter behind a small access panel.
Read the definitionThe label is Long Drain, and the one question is whether the drain hose is kinked or clogged. The remedy is to clear the display with STOP/CANCEL.
Read the supporting manualF21 (4708, 4709) and F02 (4292 family) both read Drain Problem. They have separate pages.
Read the supporting manualOE is the same idea on 796 washers: slow draining, with a drain pump filter check. Ld is the Calypso letter pair.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc L0412465 / P/N 8543703 (Sears, Roebuck and Co.) / PDF p.18 (Ld)
Manufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc L0809415 / P/N 8183014B / PDF p.22 (F21)
Manufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc L0409348 / PDF p.19 (F02)
Calypso washers 110.2206, 2408, 2506; Ld is on p. 18 of guide L0412465. The 96-inch limit comes from the 110 front-load guides.
The Calypso list asks only about the drain hose. The 796 guides add the drain pump filter under OE.
Press STOP/CANCEL after checking the hose, then rerun a drain and spin.
110 front-loaders print F21 (4708, 4709) and F02 (4292 family) as Drain Problem. The checks are the same hose questions.
Front-load guides allow a hose end up to 96 inches (2.4 m) high.
No, OE is the 796 slow-drain message. Ld is the Calypso one.
Code, symptom, part or service
OE is the 796 Kenmore message for water that drains slowly, or not at all. Inspect the drain hose for kinks and clogs, clean the drain pump filter, and keep the discharge at 96 inches (244 cm) or less above the bottom of the washer. The top-load guide also lists a drain pump that failed.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
The 796 front-load washer has a drain pump filter behind a small access panel. It catches lint, buttons, keys and coins before they reach the pump. When the washer drains slowly or not at all, the guide’s list starts with the drain hose and then this filter.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.