What it means
The Calypso guide is just as terse about Sr (Stuck Relay), giving the phrase operation failure plus a service instruction. Owners get no step here, so record Sr and book a technician.
Kenmore washer Sr / Control
The Calypso guide is just as terse about Sr (Stuck Relay), giving the phrase operation failure plus a service instruction. Owners get no step here, so record Sr and book a technician.
Also shown as Sr
The Calypso guide is just as terse about Sr (Stuck Relay), giving the phrase operation failure plus a service instruction. Owners get no step here, so record Sr and book a technician.
Copy the letters exactly and recall which phase the cycle was in.
Sr is on the display.
Your checklist / stored on this device

Copy the letters exactly and recall which phase the cycle was in.

Press STOP/CANCEL. There is no clearing key listed, so the aim is simply to stop the washer.

If the washer will not stop, pull the plug rather than reaching into the tub.

Do not try to dig into the control or panel.
Pass on the model number along with Sr.
Give us the model and the checks you have already done, and open your request from here.
Book a visit

Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.
The guide offers the label and the words washer operation failure. The relay that is stuck is not identified.
Read the supporting manualMany Calypso codes come with a simple key press or check. Sr and Or are the two where the guide goes straight to service.
Read the supporting manualThey are paired in the list with identical wording. Sr is stuck and Or is open, in the guide's terms. Neither has an owner remedy.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc L0412465 / P/N 8543703 (Sears, Roebuck and Co.) / PDF p.18
Sr shares p. 18 of guide L0412465 with Or and the other Calypso codes (110.2206, 2408, 2506); no step beyond service is printed.
Yes. The Calypso list prints Sr with that label, followed by washer operation failure and call for service.
Or is Open Relay and Sr is Stuck Relay. Both get the same advice, so tell the technician which one appeared.
The guide does not offer that for Sr. It goes straight to a service call.
If the washer behaves strangely, unplug it. Otherwise leave it off and wait for the visit.
The 110 Calypso models 2206, 2408, 2506 and 2508 in this guide.
Code, symptom, part or service
CE is the Calypso's Communications Error message. The code flashes and the washer beeps once. Wipe the display with STOP/CANCEL; a CE that keeps occurring is a service matter. No cause is named, so the owner has no repair to attempt.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.