What it means
CE is the Calypso's Communications Error message. The code flashes and the washer beeps once. Wipe the display with STOP/CANCEL; a CE that keeps occurring is a service matter. No cause is named, so the owner has no repair to attempt.
Kenmore washer CE / Communication
CE is the Calypso's Communications Error message. The code flashes and the washer beeps once. Wipe the display with STOP/CANCEL; a CE that keeps occurring is a service matter. No cause is named, so the owner has no repair to attempt.
Also shown as CE
CE is the Calypso's Communications Error message. The code flashes and the washer beeps once. Wipe the display with STOP/CANCEL; a CE that keeps occurring is a service matter. No cause is named, so the owner has no repair to attempt.
The guide's only owner step is clearing the display.
CE keeps occurring after it has been cleared with STOP/CANCEL.
Your checklist / stored on this device

The guide's only owner step is clearing the display.

The guide does not mention a held key or a damp panel, yet both are worth a glance before you start again.

Select a cycle and press START. A single CE that does not return is likely a one-off.

If CE comes back every cycle, put the washer out of use and book a technician.
The Calypso models are 110.2206, 2408, 2506 and 2508.
Give us the model and the checks you have already done, and open your request from here.
Book a visit

Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.
Only the label is given. CE flashes and the washer beeps once, with STOP/CANCEL as the remedy. Which parts exchange signals is left unsaid.
Read the supporting manualThe page header says that if any of these codes continue to occur, call for service. A code that repeats after clearing has moved from a nuisance to a service matter.
Read the supporting manualOpen Relay and Stuck Relay are both treated as washer operation failures, with service as the only step. CE has one clearing step. All three are in the same list.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc L0412465 / P/N 8543703 (Sears, Roebuck and Co.) / PDF p.18
Calypso washers 110.2206, 2408 and 2506, from the troubleshooting list on p. 18 of guide L0412465.
The guide does not say. It calls CE a Communications Error and offers only a display-clearing key press.
The guide notes CE flashes and the washer beeps once. The beep is part of the signal.
The Calypso list does not offer unplugging. If CE comes back after STOP/CANCEL, call for service.
CA and CL are current limit messages about load size. CE is a communication message with no load question.
The list header says if any code continues to occur, call for service. Once it repeats on every cycle, stop using the washer.
Code, symptom, part or service
CA is the Calypso washer's current limit message. The guide's question is whether the machine is overloaded, and its remedy is one key press that wipes the display. Take some items out before you start again. A 796 top-load uses CL for something else, so match the code to your model prefix.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.