Before work starts
After the technician has examined the appliance you are given the cost of the repair, and you decide whether to go ahead.
Independent appliance repair
We repair Kenmore dishwashers that will not start, stop mid-cycle, leave dishes dirty or flash lights. Tell us which lights blink, whether the door latches and whether water drains, then book a visit.


On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.

A Kenmore 665 dishwasher that will not run needs a closed and latched door, Control Lock off, a selected cycle and power. It also pauses repeatedly during a cycle, which is normal. If lights other than Start/Resume blink, it needs service.

Soap still in the cup, or a tablet lying on the tub floor, sends the Kenmore 665 guide to three questions: is anything blocking the lid, is the detergent fresh and free of lumps, and did the cycle really finish?

The Kenmore 665 guide gives two causes for leaks: an installation that is not level, and suds from too much detergent or the wrong kind. It also warns about rinse aid leaking from an overfilled or loose dispenser.
We have not researched code meanings for this appliance. Use its model manual, and attach a photo of the display to your request.
See the research statusWe don’t quote parts up front. The technician names any part after the diagnostic and matches it to your exact model number before anything is replaced.
What happens after you book.
Model number first.

Type in the number from the label, along with what the appliance does. A photo of the label works too.

The technician reads the code against your model, finds the failed part and gives you a cost before starting.

The new part goes in, the cycle is tested, and you hear what was done.
If Start/Resume blinks, close the door and press START/RESUME, or press it and close the door within 3 seconds. The guide says to be sure the door is closed and latched.
The 665 guide says to make sure the Control/Lock feature is off (its light would be lit) and a cycle is selected.
Check that there is power and that no fuse or breaker has tripped.
The Ultra Wash HE filters at the bottom center need periodic cleaning. See the filters page.
The guide says that if lights other than Start/Resume blink and the unit will not run, it needs service. Record which ones blink.
Book a visit if lights other than Start/Resume blink and the dishwasher will not run.
Book a visit if it will not drain or clean after the filters are clear.
Turn off the water and power if water is leaking.
Leave the pump, valve and wiring to the technician.
Arrange a diagnosticAfter the technician has examined the appliance you are given the cost of the repair, and you decide whether to go ahead.
Covered repairs under a Kenmore manufacturer warranty are handled through Kenmore. We stand behind our own work with a workmanship warranty.
The 665 guide prints only a rule: Start/Resume blinking means close the door and press start again. Other blinking lights mean service. It doesn’t decode them.
The guide we read prints no F#E# table, so we can’t say. Note which lights blink or count the pattern, then book a visit.
The 665 guide says it is normal for the dishwasher to repeatedly pause several times during a cycle.
The guide lists dishware blocking the dispenser, old or lumpy detergent and a cycle not yet finished. Check those first.
A repair that falls under the manufacturer’s warranty is handled by the manufacturer. For anything else, book a visit with us and we agree the price before we begin.
Code, symptom, part or service
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
The Kenmore 665 Ultra Wash HE dishwasher has two removable filters at the bottom center of the tub: an upper filter assembly and a lower filter. The guide says clean them periodically and never run the dishwasher without both properly locked in place.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.