Inside the appliance
Dishwasher filters. In plain English.
The Kenmore 665 Ultra Wash HE dishwasher has two removable filters at the bottom center of the tub: an upper filter assembly and a lower filter. The guide says clean them periodically and never run the dishwasher without both properly locked in place.

Where it fits.
Dishwasher filters in the appliance
At the bottom center of the tub. The upper assembly is the round piece that locks into the lower filter.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Dishwasher filters concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.

Kenmore dishwasher won't start
A Kenmore 665 dishwasher that will not run needs a closed and latched door, Control Lock off, a selected cycle and power. It also pauses repeatedly during a cycle, which is normal. If lights other than Start/Resume blink, it needs service.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Take them out
Turn the upper filter assembly a quarter turn counterclockwise and lift it out. Then grasp the lower filter in the circular opening, lift it slightly and pull it forward.
- 2
Rinse, don’t scrub hard
Rinse under running water. For hard-to-remove soil or calcium deposits from hard water, use a soft brush. The guide says not to use a wire brush or scouring pad.
- 3
Seat them right
Set the lower filter under the locating tabs, put the upper assembly into the round opening and turn it clockwise until it drops and locks. If it still turns freely, it is not locked.
- 4
Don’t run without them
The guide says operating the dishwasher without the filters installed and locked can damage it.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if the dishwasher still does not drain or clean after the filters are clean and locked.
Book a visit if lights other than Start/Resume blink and the unit will not run. The guide gives service as the step.
Arrange a diagnosticSources and model boundaries.
These sources back up the Dishwasher filters guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Ultra Wash HE dishwasher 665.1335
Go by the instructions for your exact model. Check how we research these pages.
Where are the filters on my Kenmore dishwasher?
On the 665 Ultra Wash HE they are at the bottom center of the tub. Your guide’s diagram shows the position for your model.
How often do I clean them?
The 665 guide says periodically, without a number. Rinse them when you see soil or a gritty film, and follow the removal steps.
Can I use a brush?
A soft brush for hard soil or calcium deposits. The guide says not to use a wire brush or scouring pad.
Why are lights blinking?
The 665 guide says that if lights other than Start/Resume blink and the unit won’t run, it needs service. Start/Resume blinking means close the door and press START/RESUME.
Code, symptom, part or service
Link the message to what comes next.
Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
Dishwasher repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

