Start from the symptom
Kenmore dishwasher won't start.
A Kenmore 665 dishwasher that will not run needs a closed and latched door, Control Lock off, a selected cycle and power. It also pauses repeatedly during a cycle, which is normal. If lights other than Start/Resume blink, it needs service.

Start with safe observations.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Door closed and latched
Check large casseroles are not hitting the wash system at the back. Adjust loading so the door shuts.
- 2
Control Lock off
The Lock indicator must not be lit.
- 3
A cycle selected
Choose a cycle, then START/RESUME. If that light blinks, close the door and press START/RESUME, or press it and close the door within 3 seconds.
- 4
Power
Look for a tripped breaker or blown fuse.
- 5
Will not fill
Confirm the water is on, the float is free and there are no suds in the tub.
Systems a technician may investigate.
We don’t quote parts up front. The technician names any part after the diagnostic and matches it to your exact model number before anything is replaced.
When observation becomes a service request.
Leave internal testing to a technician.
Any light other than Start/Resume blinks and the unit will not run, or it still will not start with the door, lock and power right. Book a visit.
Arrange a diagnosticSources and model boundaries.
These sources back up the Kenmore dishwasher won't start guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Ultra Wash dishwasher 665.1335
Go by the instructions for your exact model. Check how we research these pages.
Why does my dishwasher pause mid-cycle?
The guide says it is normal for the dishwasher to pause several times during a cycle.
Why will it not start?
The door, the Lock, no cycle chosen or no power. Those four come first in the guide.
What do blinking lights mean?
The 665 guide prints only that lights other than Start/Resume blinking with no run needs service, not a code table.
Why will it not fill?
Water off, a stuck float, or suds. Check each.
Code, symptom, part or service
Link the message to what comes next.
Kenmore dishwasher F6E1: what the documents print
Kenmore's Ultra Wash 665 dishwasher guide does not print F6E1. It lists a blink rule and no code table instead. Close the door and press START/RESUME; if other lights keep blinking, arrange a technician.
Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
Dishwasher repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.
