Start from the symptom
Kenmore dishwasher controls not responding.
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.

Start with safe observations.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Look for the Lock indicator
When the Lock light is on, all buttons are disabled and pressing a pad flashes the light three times. The dishwasher cannot start while locked.
- 2
Release it
Press and hold SANI RINSE for three seconds. The light goes off.
- 3
Close and latch the door
Large dishes can interfere with the wash system at the back. Adjust loading so the door shuts and latches.
- 4
Check power
A circuit breaker or fuse may have tripped.
- 5
Press START/RESUME again
If Start/Resume blinks, close the door and press START/RESUME, or press it and close the door within 3 seconds.
Systems a technician may investigate.
We don’t quote parts up front. The technician names any part after the diagnostic and matches it to your exact model number before anything is replaced.
When observation becomes a service request.
Leave internal testing to a technician.
Lights other than Start/Resume blink and the unit will not run, or the pads stay dead with the lock off and power good. Book a visit.
Arrange a diagnosticSources and model boundaries.
These sources back up the Kenmore dishwasher controls not responding guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Ultra Wash dishwasher 665.1335
Go by the instructions for your exact model. Check how we research these pages.
Why do my dishwasher buttons not work?
Control Lock. The guide says all buttons are disabled while the Lock indicator is lit.
How do I unlock the controls?
Press and hold SANI RINSE for three seconds. The same press turns the lock on.
Does the door still open while locked?
Yes. The guide says the door can still be opened and closed while the controls are locked.
What if other lights blink?
If lights other than Start/Resume blink and it will not run, the guide says service is needed.
Code, symptom, part or service
Link the message to what comes next.
Kenmore dishwasher F6E1: what the documents print
Kenmore's Ultra Wash 665 dishwasher guide does not print F6E1. It lists a blink rule and no code table instead. Close the door and press START/RESUME; if other lights keep blinking, arrange a technician.
Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
Dishwasher repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.
