Start from the symptom
Kenmore dishwasher detergent dispenser.
Soap still in the cup, or a tablet lying on the tub floor, sends the Kenmore 665 guide to three questions: is anything blocking the lid, is the detergent fresh and free of lumps, and did the cycle really finish?

Start with safe observations.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Look for blockers
Cookie sheets, cutting boards and large containers can stop the dispenser from opening.
- 2
Use fresh detergent
The guide wants detergent that is fresh and lump-free.
- 3
Confirm the cycle finished
The Complete indicator should be on. If not, close the door and press START/RESUME.
- 4
Use the right amount
The guide has a table by water hardness. Premeasured packs and tablets go in the main compartment with the lid closed.
- 5
Rinse aid
Fill the rinse aid dispenser to 1/2 FULL and wipe spills; spilled rinse aid makes suds.
Systems a technician may investigate.
We don’t quote parts up front. The technician names any part after the diagnostic and matches it to your exact model number before anything is replaced.
If the display adds a code.
Keep the exact message.
We have not researched code meanings for this appliance. Use its model manual, and attach a photo of the display to your request.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
The lid will not open or close, or the dispenser still holds detergent with nothing blocking it. Book a visit.
Arrange a diagnosticSources and model boundaries.
These sources back up the Kenmore dishwasher detergent dispenser guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Ultra Wash dishwasher 665.1335
Go by the instructions for your exact model. Check how we research these pages.
Why is detergent left in the cup?
Something blocks the lid, the detergent is old or clumped, or the cycle has not finished.
Where do tablets go?
In the main compartment with the lid closed, per the guide.
How much rinse aid?
Fill until the indicator reads 1/2 FULL. Do not overfill.
Can spilled rinse aid cause suds?
Yes. The guide says to clean up spills because they create excessive suds.
Code, symptom, part or service
Link the message to what comes next.
Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
Dishwasher repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.
