Start from the symptom
Kenmore dishwasher leaking.
The Kenmore 665 guide gives two causes for leaks: an installation that is not level, and suds from too much detergent or the wrong kind. It also warns about rinse aid leaking from an overfilled or loose dispenser.

Start with safe observations.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Check that it is level
The guide says to be sure the dishwasher is installed properly and level.
- 2
Measure detergent
Suds can make a dishwasher overflow. Use only dishwasher detergent, and use less in soft water. Try another brand if suds continue.
- 3
Rinse aid dispenser
Make sure the lid is securely attached and do not overfill.
- 4
Water sitting in the tub
That is a draining problem, not a leak. The guide's list: disposer knockout plug removed, no kinks in the drain hose, no food in the drain or disposer, and clean ULTRA WASH filters.
Systems a technician may investigate.
These parts are linked to the symptom. Noticing the symptom does not show that any single part has failed.
If the display adds a code.
Keep the exact message.
We have not researched code meanings for this appliance. Use its model manual, and attach a photo of the display to your request.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
Water still appears with the unit level, detergent measured and the drain clear. Book a visit and shut off the water supply if it keeps leaking.
Arrange a diagnosticSources and model boundaries.
These sources back up the Kenmore dishwasher leaking guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Ultra Wash dishwasher 665.1335
Go by the instructions for your exact model. Check how we research these pages.
Why is my dishwasher leaking?
The guide lists not level and suds from too much or wrong detergent.
Can rinse aid leak?
Yes, if the lid is loose or it is overfilled.
What detergent should I use?
Dishwasher detergent only, measured accurately; less in soft water.
Do the filters matter?
The guide has you clean the ULTRA WASH filters when water remains in the tub or food soils stay on dishes. Check them if water backs up.
Code, symptom, part or service
Link the message to what comes next.
Kenmore dishwasher controls not responding
On the Kenmore 665 Ultra Wash dishwasher, buttons that do nothing usually mean Control Lock is on. All pads are disabled when the Lock indicator is lit; hold SANI RINSE for three seconds to release it. Otherwise check the door latch and power.
Dishwasher filters
The Kenmore 665 Ultra Wash HE dishwasher has two removable filters at the bottom center of the tub: an upper filter assembly and a lower filter. The guide says clean them periodically and never run the dishwasher without both properly locked in place.
Dishwasher repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.
