Maintenance

Removing and replacing a Kenmore oven door

Kenmore's four 790 range guides use four different door-removal methods, so use the one in your guide. All of them say the door is heavy, to hold it by its sides and to lay it flat with the inside face down. Do not force a door that is locked after self-clean; wait for the light to go out.

Open oven with its door removed and leaning on a folded towel on the floor beside the range, hinge arms still showing on the door.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Four 790 guides, four methods: use the one in your own guide. 1234
  • The door is heavy; lay it flat with the inside facing down. 1234
  • Do not close the door until the racks are fully in place, and do not strike the glass. 13
  • A door locked after self-clean waits for the oven to cool; do not force it. 2
  • Hinge arms can snap back and pinch fingers if you pull them open by hand. 24

Do all Kenmore oven doors come off the same way?#

No. The four 790 range guides give four methods: a lock on each hinge support, a 4-inch stop with a straight lift, hinge locks and roller pins, and a screw at each hinge. Use the one from your own guide. 1234

The table names the guide each method comes from. If you are unsure which family you have, start with the number before the dot in the model number.

GuideMethod in shortPage
Elite dual-fuel slide-in, 790.4103/4104Pull up a lock on each hinge support and hook it over the hinge lever1, p. 44
Range 790.7540Open about 4 inches to the stop and lift the door up and off the hinges2, p. 27
Elite gas slide-in, 790.4260/4261Fully open, pull the hinge locks down, close to 10 degrees, lift the hinge arms off the roller pins3, p. 38
Range 790.9375Remove a screw at each hinge, close to quarter-open, lift up and off4, p. 20

All four say the door is heavy. For safe, temporary storage, lay it flat with the inside face down. 1234

Oven door lying flat on a folded towel on a kitchen counter with its hinge brackets and steel handle showing.
Inside face down, on something soft. 1234

How do I remove the door on an Elite dual-fuel slide-in?#

Open the door fully, pull the lock on each hinge support up and onto the hinge lever hook, grip the door by its sides and pull the bottom up and toward you, then rotate the top toward the range to free the levers. 1

  1. 1

    Open the door fully#

    Take it to the fully opened position. 1

  2. 2

    Engage the hinge locks#

    Pull up the lock on each hinge support and engage it onto the hinge lever hook. You may need to press down a little on the door to pull the lock fully over the hook. 1

  3. 3

    Lift the door away#

    Grab the door by the sides and pull the bottom up and toward you to free the hinge supports. Keep pulling the bottom toward you while turning the top toward the range, until the hinge levers come out. 1

  4. 4

    Replace in reverse#

    Put the hinge supports and levers into the hinge slots, open the door fully, then disengage the lock from the hook on both sides. The guide notes that the supports must be fully engaged before you unlock the levers. Then close the door. 1

Close view of a metal oven door hinge arm with a small lock lever pulled down beside it, the open door glass below.
The hinge lock engaged for removal. 13

How do I remove the door on a 790.7540 range?#

Open the door about 4 inches to the stop position, grasp it at the side edges and lift it up and off the hinges. That is the whole removal. Put it back by sliding it down onto the hinges as far as it will go. 2

For the replacement, the guide has two cautions. Make sure the hinge arms are in the stop position, and be careful when pulling them open by hand, because they may snap back against the oven frame and pinch fingers. Hold the door at the sides near the top. 2

If the door does not line up with the frame, remove it and repeat the steps. 2

How do I remove the door on an Elite gas slide-in?#

Open the door fully, pull both hinge locks down toward the door, hold it by the sides, close it to 10 degrees from the frame and lift the hinge arms off the roller pins. The guide says a small flat-blade screwdriver may be needed for the locks. 3

  1. 1

    Open the door completely#

    Horizontal with the floor. 3

  2. 2

    Pull the hinge locks down#

    On both left and right hinges, pull the locks down from the oven frame toward the door. A tool such as a small flat-blade screwdriver may be needed. 3

  3. 3

    Hold the sides, not the handle#

    Firmly grasp both sides of the door. The guide says not to use the door handle. 3

  4. 4

    Close it to 10 degrees#

    Close the door until it is 10 degrees from the door frame. 3

  5. 5

    Lift the hinge arms off the roller pins#

    Lift the oven door hinge arms over the roller pins on each side of the oven frame. 3

To replace the door, hold it at the same angle and seat the hook of each hinge arm over the roller pins until it is fully seated. Open the door fully and push both hinge locks back up into the oven frame. Then close the door. 3

How do I remove the door on a 790.9375 range?#

Open the door, take out the screw near each hinge inside the door, close the door to the quarter-open position, grip it firmly on both sides and lift up and off the hinges. 4

To replace it, make sure the hinge arms are in the quarter-open position. Hold the door at the sides near the top and insert the hinge arms into the slots at the bottom of the door. They must go in evenly and as far as they can go. As on the 790.7540, the hinges may snap back and pinch fingers if you pull them open by hand. 4

If the door does not line up with the oven frame, remove it and start the steps again. 4

How do I look after the door and the glass?#

Close the door only after the racks are fully in place, and keep pots, pans and anything else from hitting the glass. The guide says scratching, hitting or jarring can weaken the glass and make it likelier to break later. 13

That caution is in both the dual-fuel and the gas guides, headed "Special Door Care Instructions", which says that most oven doors contain glass that can break. 13

If the door is off for cleaning, the guides send you to their cleaning charts for the door itself. They do not give a separate glass-cleaning method on the removal pages. 124

Two hands holding the sides of a stainless oven door and lifting it away from the range at an angle.
Grip the sides, lift at your guide's angle and set the door down flat. 1234

Why is the oven door locked and how do I release it?#

On a self-cleaning oven the door locks by motor. The 790.7540 guide says it takes about 15 seconds to lock, the Door Locked light stays on during the cycle, and the door can be opened about an hour after cooling once that light is out. 2

The same guide says not to clean the door gasket, which is woven and needed for a good seal, and to hand-clean the door liner outside the gasket and the oven frame before a self-clean. 2

A door locked by the oven lockout is a different matter, covered in the lockout guide. The range door problems page has the rest, and the oven door lock entry explains the part.

When should I leave the door to a technician?#

When it will not seat, will not latch or will not release. The guides say what to do if the door sits crooked: take it off and repeat the steps. If it still does not line up, or the lock does not release after the oven cools, book a visit. 24

The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. You can see what we repair on the range service page.

Flashlight glow on a small blank rating label on the frame beside an open dryer door hinge, the drum visible at right.
The number before the dot points to your guide.

Sources#

  1. Use & Care Guide, Kenmore Elite dual-fuel slide-in range 790.4103/4104Kenmore / Sears Brands · Document L0810108 (part 318203893 Rev. A) · pp. 44 (Removing and Replacing the Oven Door, Special Door Care Instructions)
  2. Use & Care Guide, Kenmore range 790.7540Kenmore / Sears Brands · Document 1608081L (part 318200773 Rev. A) · pp. 22-23 (Self-Cleaning), 27 (To Remove and Replace Oven Door)
  3. Use & Care Guide, Kenmore Elite slide-in gas range 790.4260/4261Kenmore / Sears Brands · Document 1403611L (part 139901309 Rev. A) · p. 38 (Removing and Replacing the Oven Door)
  4. Use & Care Guide, Kenmore range 790.9375xKenmore / Sears Brands · Document L0207081 (part 316257907) · p. 20 (To Remove and Replace Oven Door)

Here to help

Good questions.
Clear answers.

Talk to our team
Do all Kenmore oven doors come off the same way?

No. The four 790 guides we read give four methods: hinge lever locks, lifting off at a 4-inch stop, hinge locks and roller pins, and screws at the hinges. Use the one from your own guide. See sources 1 to 4.

Is an oven door heavy?

Every guide says so. The advice is to lay the door flat with its inside face down when you set it aside. Grip the sides, not the handle on the gas range. See sources 1 to 4, and source 3, page 38.

Why will the door not open after a self-clean cycle?

The door stays locked while the oven is hot. The 790.7540 guide says to wait until the oven has cooled for about an hour and the Door Locked light has gone out, and not to force the door. See source 2, page 23.

Can I close the door before the racks are in place?

No. The guides say not to close the oven door until all the oven racks are fully in place, and not to hit the glass with pots or pans. Stress to the glass can weaken it. See source 1, page 44.

What if the door will not sit straight after I put it back?

Two guides say the same thing: remove it and repeat the steps, with the hinge arms in the right position and seated evenly. See source 2, page 27, and source 4, page 20.

Let’s take care of it.

Still going after all these years.
Let’s keep it that way.