What it means
dE2 turns up in the same 796 front-load guides as dE1, beside the door text. No guide separates the two. Shut the door firmly and press START/PAUSE; if the open-door message stays, book a technician.
Kenmore washer dE2 / Door
dE2 turns up in the same 796 front-load guides as dE1, beside the door text. No guide separates the two. Shut the door firmly and press START/PAUSE; if the open-door message stays, book a technician.
Also shown as dE2
dE2 turns up in the same 796 front-load guides as dE1, beside the door text. No guide separates the two. Shut the door firmly and press START/PAUSE; if the open-door message stays, book a technician.
A door that sat against the latch may not have locked.
dE2 stays on after you shut and latch the door.
Your checklist / stored on this device

A door that sat against the latch may not have locked. Reseat it.

Do not press repeatedly. Give the washer a moment before the drum begins.

A basket stuffed too full can stop the latch from catching.

Look carefully at the second character so you give the technician the right code.

If the door is shut and locked and dE2 stays, book with us.
Give us the model and the checks you have already done, and open your request from here.
Book a visit
Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.

Component reference
A Kenmore washer locks its door or lid while a cycle runs, and it will not spin unless the lock has engaged.
Read the definitionIn the 796 front-load troubleshooting table it is an icon printed beside the door-not-closed sentence. The listed remedy is closing the door and pressing START/PAUSE.
Read the supporting manualThe display shows them differently, and people search for each. The guides give them the same text, so the pages have the same advice in different words.
Read the supporting manualThe advice is to call when the door is shut and locked yet the open-door message remains.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1909134L / P/N MFL68005592 (Transform SR Brands) / PDF p.46 (front-load, dE1/dE2 graphics)
Manufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1807405L / P/N MFL68005554 / PDF p.31
From the same two guides as dE1: 1909134L p. 46 and 1807405L p. 31.
The display shows dE2 differently from dE1, and people search for each. The guides give them the same text and the same remedy.
The washer will not operate unless the door is locked, so extra presses do nothing. Reseat the door and press START/PAUSE once.
The guide does not say. It lists only closing the door properly.
Write the characters exactly and the model number, which for this layout starts with 796.
No. F22 is the 110 front-load door lock message.
Code, symptom, part or service
dE means the lid or door is not closed properly. The 796 top-load displays it if you hit START while the lid is up. Front-loaders in the 796 line show dE1 or dE2 for the same condition, and 110 front-loaders print F22 instead. Close it fully and press START again.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
A Kenmore washer locks its door or lid while a cycle runs, and it will not spin unless the lock has engaged. The 796 guides print dE for a door or lid left open and dL for a lid lock switch error. Calypso washers print LS for the lid switch, and the 110 front-load guide lists F22 as “Front door lock.”
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.