Kenmore dryer AF / Airflow

Kenmore dryer
error AF

Dryer / display referenceAF

AF on a Kenmore Elite HE 110.8772 dryer says the vent may be crushed or blocked. Run the dryer for 5 to 10 minutes and hold your hand under the outside hood. No air means clean the exhaust system or replace the vent with heavy or flexible metal vent.

Also shown as AF

Last reviewed

Dryer / display referenceAF
Meaning
AF on a Kenmore Elite HE 110.8772 dryer says the vent may be crushed or blocked. Run the dryer for 5 to 10 minutes and hold your hand under the outside hood. No air means clean the exhaust system or replace the vent with heavy or flexible metal vent.
Who handles it
Owner checks first, then a technician
Related codes
Source
Use & Care Guide, Kenmore Elite HE dryer 110.8772

What Kenmore dryer AF means.

What it means

AF on a Kenmore Elite HE 110.8772 dryer says the vent may be crushed or blocked. Run the dryer for 5 to 10 minutes and hold your hand under the outside hood. No air means clean the exhaust system or replace the vent with heavy or flexible metal vent.

What you can safely check

Heat and lint sit in a blocked vent.

When to call a technician

AF returns after the vent is clean and the hood test shows strong airflow.

Your checklist / stored on this device

Safe checks, in order.

0 of 5 checks done
  1. Kenmore dryer AF: Dryers in a thoughtfully designed home
    Illustration. Follow your model’s instructions.
    Before you begin

    Switch the dryer off and let it cool

    Heat and lint sit in a blocked vent. Give the drum time to cool before you slide the dryer out or touch the duct.

  2. A worn rating label on the rim of an older top-load washer
    Illustration. Follow your model’s instructions.
    Check 2

    Look behind the dryer

    Check whether the duct is crushed, kinked or squeezed against the wall. A flattened section chokes the air even if the rest looks clear.

  3. Over the shoulder of a technician in a navy shirt holding a tablet with a blank checklist, a white washer behind him.
    Illustration. Follow your model’s instructions.
    Check 3

    Do the hood test

    Run the dryer for 5 to 10 minutes, then hold a hand under the outside exhaust hood. You should feel a steady push of air.

  4. A technician with a washer drain pump in hand
    Illustration. Follow your model’s instructions.
    Check 4

    Clean or replace the vent

    If you feel little or no air, clear lint from the exhaust system, or replace the vent with heavy metal or flexible metal vent. Plastic and metal foil are the types the guide warns against.

  5. Illustration. Follow your model’s instructions.
    Check 5

    Rerun a normal load

    If AF still shows once air is moving, note it down and book a visit.

Still showing AF?

Give us the model and the checks you have already done, and open your request from here.

Book a visit

The airflow path.

Conceptual Dryer sectionLint filterBlowerExhaust ductOutside vent1234
  1. 2Blower

Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.

Parts behind the message.

Short section of flexible foil dryer duct with a metal clamp and a clump of gray lint spilling from one end, on a wooden workbench.

Component reference

Dryer exhaust vent

The exhaust vent carries hot, moist air outside.

Read the definition

A little more context.

What does AF mean on a Kenmore Elite HE dryer?

Kenmore's text reads, in effect, that the vent may be crushed or blocked. It appears in the section on first-cycle diagnostics and again in the troubleshooting page, so you may see it right after installation.

Read the supporting manual

Why does the guide stress metal vent?

Troubleshooting says to replace the exhaust vent with heavy metal or flexible metal vent, and the venting pages warn against plastic or metal foil vent. Lint and heat risk fire in a restricted duct, so the warning carries weight.

Read the supporting manual

How does AF differ from L2?

AF is about air leaving the dryer. L2, on the same guide, is about the heater not starting while the drum turns, which points to household power. Different symptoms, different first checks.

Read the supporting manual

The manual behind the message.

Manufacturer document

Use & Care Guide, Kenmore Elite HE dryer 110.8772

Kenmore (guide as published by Sears / Transform SR Brands)

Doc L0708325 / P/N W10136973A (Sears, Roebuck and Co.) / PDF p.19 (first-cycle diagnostic); PDF p.28 (airflow test)

Elite HE dryer 110.8772, guide L0708325, with AF on pp. 19 and 28 and no F30 anywhere.

Here to help

Good questions.
Clear answers.

Talk to our team
Is AF the same as F30?

Kenmore prints AF in this guide. F30 never shows up in the Kenmore guides we checked, so we attach no meaning to it.

When does AF show during a new install?

The guide lists it among the diagnostic codes you may see in the first cycle.

Can I vacuum the duct myself?

Cleaning lint from the exhaust system is a step the guide gives. Keep the dryer unplugged while you work, and stop if the duct is hard to reach.

Does a clean lint screen fix AF?

The guide does not tie AF to the lint screen. It points to the vent and hood, so check those.

How long should the hood test run?

The guide says 5 to 10 minutes before you check for air movement.

Let’s take care of it.

Still going after all these years.
Let’s keep it that way.