Before work starts
After the technician has examined the appliance you are given the cost of the repair, and you decide whether to go ahead.
Independent appliance repair
We repair Kenmore ice makers in refrigerators that make no ice, too little, too much or bad-tasting ice. Tell us the model number, how long it has been installed and whether the dispenser still works, then book a visit.


For a Kenmore bottom-freezer ice maker that makes nothing, the guide lists a fresh install, the power switch, a dirty ice sensor, no water supply, a blocked shut-off arm or sensor, and reverse osmosis pressure. A new unit can take 12 to 24 hours to make ice.

Kenmore names six reasons for ice with a bad taste or odor: minerals such as sulfur in the water, a new ice maker, old ice, poorly wrapped food, a dirty refrigerator and a dirty ice bin. Throw away old ice, wash and dry the bin, and rewrap food.
We have not researched code meanings for this appliance. Use its model manual, and attach a photo of the display to your request.
See the research statusWe don’t quote parts up front. The technician names any part after the diagnostic and matches it to your exact model number before anything is replaced.

The automatic ice maker takes in water, freezes it into cubes and sends them to the bin. The Kenmore 795 guide says a new refrigerator takes 12 to 24 hours to start making ice and 72 hours to reach full output, and lists the switch, the ice sensor, the shut-off arm and the water supply as the usual checks.

This cartridge treats the water on its way to the dispenser and the ice maker. Kenmore’s refrigerator guides say to replace it about every six months, when the indicator comes on, when dispenser output drops or when the ice cubes get smaller than normal.
What happens after you book.
Model number first.

Type in the number from the label, along with what the appliance does. A photo of the label works too.

The technician reads the code against your model, finds the failed part and gives you a cost before starting.

The new part goes in, the cycle is tested, and you hear what was done.
The 795 guide says a newly installed refrigerator takes 12 to 24 hours to start making ice and 72 hours for full production.
Confirm the ICEMAKER switch is on and the shut-off arm moves freely, or that the sensor path is clear.
The supply valve must be fully open and the line unkinked. The guide gives 20 to 120 psi without a filter, 40 to 120 psi with one.
The guide says to replace the filter about every six months, and that an exhausted filter and smaller cubes go together.
The guide says not to put fingers or hands on the ice-making mechanism while the refrigerator is plugged in.
Book a visit if there is no ice after 72 hours with the switch on and the water supply confirmed.
Book a visit if the ice maker makes too much ice or the ice stays discolored.
Book a visit for water leaking near the ice maker or filter.
Arrange a diagnosticAfter the technician has examined the appliance you are given the cost of the repair, and you decide whether to go ahead.
Covered repairs under a Kenmore manufacturer warranty are handled through Kenmore. We stand behind our own work with a workmanship warranty.
We book them. The guides we hold cover refrigerator ice makers only, so we can’t quote a freestanding guide. Give us the model number when you book.
The guide lists the switch, a blocked sensor or arm, a closed or kinked water supply, low pressure and a freezer warmer than 0°F. Check those, then book.
The guide says an exhausted filter makes smaller cubes, and ice kept too long shrinks, clouds and tastes stale. Empty and wash the bin.
The guide says the icemaker water valve buzzes as it fills, even before the water line is hooked up if the switch is on.
A repair that falls under the manufacturer’s warranty is handled by the manufacturer. For anything else, book a visit with us and we agree the price before we begin.
Code, symptom, part or service
For a Kenmore bottom-freezer ice maker that makes nothing, the guide lists a fresh install, the power switch, a dirty ice sensor, no water supply, a blocked shut-off arm or sensor, and reverse osmosis pressure. A new unit can take 12 to 24 hours to make ice.
The automatic ice maker takes in water, freezes it into cubes and sends them to the bin. The Kenmore 795 guide says a new refrigerator takes 12 to 24 hours to start making ice and 72 hours to reach full output, and lists the switch, the ice sensor, the shut-off arm and the water supply as the usual checks.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.