Inside the appliance
Refrigerator ice maker. In plain English.
The automatic ice maker takes in water, freezes it into cubes and sends them to the bin. The Kenmore 795 guide says a new refrigerator takes 12 to 24 hours to start making ice and 72 hours to reach full output, and lists the switch, the ice sensor, the shut-off arm and the water supply as the usual checks.

Where it fits.
Refrigerator ice maker in the appliance
The 795 guide’s features diagram lists the icemaker and the ice bin, and notes that locations vary by model. Check your own guide’s diagram.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Refrigerator ice maker concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore refrigerator frost buildup
Frost in a Kenmore 795 refrigerator mostly comes from moist air getting in: doors opened often, doors that do not close fully, humid weather or unwrapped food. The guide treats frost inside sealed packages as normal for wet foods stored too long.

Kenmore refrigerator temperature problems
For a Kenmore 795 refrigerator that is too warm, too cold or uneven, the guide lists install time, blocked vents, door openings, hot food, room temperature and the control setting. Adjust one increment at a time and let the temperature settle.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Wait for a new one
The guide says a newly installed refrigerator starts making ice in 12 to 24 hours and takes 72 hours for full production. It makes roughly 70 to 210 cubes a day.
- 2
Check the switch and the arm
Confirm the ICEMAKER ON/OFF switch is on. If the ice maker has a shut-off arm, make sure it moves freely. If it has the electronic sensor, keep a clear path between the two sensors.
- 3
Look at the water side
The supply valve must be fully open and the line not kinked. The guide gives 20 to 120 psi without a water filter and 40 to 120 psi with one, and warns that reverse osmosis systems can drop the pressure too low.
- 4
Check the freezer and the sensor
For normal ice the freezer should be at 0°F, and frost or debris on the ice-detecting sensor can stop production.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if there is still no ice after the first 72 hours, the switch is on and the water supply is confirmed.
Book a visit if the ice maker makes too much ice, or if the ice is discolored and the problem continues after you discard the first batches.
Keep fingers away from the ice-making mechanism while the refrigerator is plugged in; the guide says not to touch it.
Arrange a diagnosticSources and model boundaries.
These sources back up the Refrigerator ice maker guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore Elite refrigerators 795.7802/7804/7902/7904
- Use & Care Guide, Kenmore bottom-freezer refrigerator 795.7248
Go by the instructions for your exact model. Check how we research these pages.
How long until a new refrigerator makes ice?
The 795 guide says 12 to 24 hours for ice to start and 72 hours for full production. It also says to throw away the first few batches.
Why is my ice maker not making ice?
The guide’s list: not turned on, sensor obstructed, no water supply or closed valve, shut-off arm or sensor blocked, low water pressure, or a freezer warmer than 0°F.
Why is there so little ice?
Demand above capacity, an exhausted water filter and doors left open are listed. A filter older than six months, or smaller cubes, points to a change.
Why does my ice taste bad?
The guide lists minerals in the water, ice stored too long, uncovered food nearby and a dirty bin. It says to empty and wash the bin and dry it before putting it back.
Code, symptom, part or service
Link the message to what comes next.
Kenmore refrigerator frost buildup
Frost in a Kenmore 795 refrigerator mostly comes from moist air getting in: doors opened often, doors that do not close fully, humid weather or unwrapped food. The guide treats frost inside sealed packages as normal for wet foods stored too long.
Refrigerator water filter
This cartridge treats the water on its way to the dispenser and the ice maker. Kenmore’s refrigerator guides say to replace it about every six months, when the indicator comes on, when dispenser output drops or when the ice cubes get smaller than normal.
Refrigerator repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

