Inside the appliance
Refrigerator water filter. In plain English.
This cartridge treats the water on its way to the dispenser and the ice maker. Kenmore’s refrigerator guides say to replace it about every six months, when the indicator comes on, when dispenser output drops or when the ice cubes get smaller than normal.

Where it fits.
Refrigerator water filter in the appliance
On the 795.7248 it sits in the compartment behind the lower door bin. Other 795 models place it according to their diagram.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Refrigerator water filter concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore refrigerator frost buildup
Frost in a Kenmore 795 refrigerator mostly comes from moist air getting in: doors opened often, doors that do not close fully, humid weather or unwrapped food. The guide treats frost inside sealed packages as normal for wet foods stored too long.

Kenmore refrigerator temperature problems
For a Kenmore 795 refrigerator that is too warm, too cold or uneven, the guide lists install time, blocked vents, door openings, hot food, room temperature and the control setting. Adjust one increment at a time and let the temperature settle.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Know the four signs
The 795 guides list: about every six months, the filter indicator on, lower dispenser output, and smaller ice cubes.
- 2
Swap it the way the guide shows
On the 795.7248, lift out the lower door bin, swing the filter out and turn it counterclockwise. Insert the new filter, line up the arrows and put the bin back. A little water may drain, so hold a cup under the head.
- 3
Flush the new one
After a swap, dispense 2.5 gallons in cycles of 30 seconds on and 60 seconds off, about five minutes in all, to clear trapped air.
- 4
Reset the indicator
On the 795.7248, press and hold the Water Filter button for 3 seconds to reset the light.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if the dispenser or ice stays weak after a fresh filter and an open supply valve.
Book a visit for water on the floor near the filter head or the supply line.
Arrange a diagnosticSources and model boundaries.
These sources back up the Refrigerator water filter guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore bottom-freezer refrigerator 795.7248
- Use & Care Guide, Kenmore Elite refrigerators 795.7802/7804/7902/7904
Go by the instructions for your exact model. Check how we research these pages.
How often should I change the filter?
About every six months, per the Kenmore 795 guides, or sooner if the indicator comes on, dispenser output drops or the cubes shrink.
Do I need a bypass plug?
The 795.7248 guide says it does not require a bypass plug when the filter is out, though it recommends running with a filter in place.
Why does my water taste off?
The guide says sulfur and other minerals can cause taste and odor, and that a filter may not remove everything. Discard the first batches of ice after an install.
Should I flush the filter after changing it?
Yes. The 795.7248 guide gives 2.5 gallons in 30-seconds-on, 60-seconds-off cycles, then a 3-second hold of the Water Filter button.
Code, symptom, part or service
Link the message to what comes next.
Kenmore refrigerator frost buildup
Frost in a Kenmore 795 refrigerator mostly comes from moist air getting in: doors opened often, doors that do not close fully, humid weather or unwrapped food. The guide treats frost inside sealed packages as normal for wet foods stored too long.
Refrigerator ice maker
The automatic ice maker takes in water, freezes it into cubes and sends them to the bin. The Kenmore 795 guide says a new refrigerator takes 12 to 24 hours to start making ice and 72 hours to reach full output, and lists the switch, the ice sensor, the shut-off arm and the water supply as the usual checks.
Refrigerator repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

