What it means
On the Kenmore 796.2927 top-load, dL is the message about the lid's lock switch. Close the lid properly and press START/PAUSE; no spin happens until the lid locks. If dL stays with the lid shut, the guide moves on to service.
Kenmore washer dL / Door
On the Kenmore 796.2927 top-load, dL is the message about the lid's lock switch. Close the lid properly and press START/PAUSE; no spin happens until the lid locks. If dL stays with the lid shut, the guide moves on to service.
Also shown as dL
On the Kenmore 796.2927 top-load, dL is the message about the lid's lock switch. Close the lid properly and press START/PAUSE; no spin happens until the lid locks. If dL stays with the lid shut, the guide moves on to service.
Push it all the way down.
dL outlasts a closed, locked lid.
Your checklist / stored on this device

Push it all the way down. A spin needs the lid locked.

This restarts the cycle once the lid is closed.

Never reach into the lock opening. Do not tape or hold the switch.

If it keeps coming back with the lid closed, stop there and do not force the lid.

Quote the model, 796.2927, and say that dL stays.
Give us the model and the checks you have already done, and open your request from here.
Book a visit
Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.

Component reference
A Kenmore washer locks its door or lid while a cycle runs, and it will not spin unless the lock has engaged.
Read the definitionThe row is titled lid lock switch error, and its steps are to close the lid properly and press START/PAUSE.
Read the supporting manualdE is the message for START pressed while the lid is up. dL appears after the lid is closed but the lock does not register. The troubleshooting table lists them in separate rows.
Read the supporting manualOther web pages give dL other meanings. No Kenmore guide we read does, so this page uses only the 2927 text.
Read the supporting manualManufacturer document
Kenmore (guide as published by Sears / Transform SR Brands)
Doc 1007244L / P/N MFL42065471 / PDF p.27 (row after dE)
Kenmore 796.2927 top-load washer, guide 1007244L, p. 27 (the row after dE).
No. dE covers the open lid. dL is shown after the lid is closed but the lock does not register.
Spinning requires a locked lid, per the guide.
Different Kenmore families used it differently. Only the 2927 guide is used here.
Close the lid properly and press START/PAUSE. If dL outlasts a closed, locked lid, stop and call.
No. Forcing the lid can damage the lock and the switch.
Code, symptom, part or service
dE means the lid or door is not closed properly. The 796 top-load displays it if you hit START while the lid is up. Front-loaders in the 796 line show dE1 or dE2 for the same condition, and 110 front-loaders print F22 instead. Close it fully and press START again.
Start with what the display and the lid or door say. A Kenmore washer will not spin until the lid or door is latched, and an out-of-balance load, a slow drain or too many suds can each hold the spin back. Rebalance, check the drain, then book a visit.
A Kenmore washer locks its door or lid while a cycle runs, and it will not spin unless the lock has engaged. The 796 guides print dE for a door or lid left open and dL for a lid lock switch error. Calypso washers print LS for the lid switch, and the 110 front-load guide lists F22 as “Front door lock.”
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.