What it means
On the 405.7608#, a three-second press of + and - together locks the panel; LOC flashes and then stays lit. That is a panel lock rather than an error, and the oven door stays free.
Kenmore range LOC / Mode
On the 405.7608#, a three-second press of + and - together locks the panel; LOC flashes and then stays lit. That is a panel lock rather than an error, and the oven door stays free.
Also shown as LOC
On the 405.7608#, a three-second press of + and - together locks the panel; LOC flashes and then stays lit. That is a panel lock rather than an error, and the oven door stays free.
Press both pads at the same time for three seconds.
Holding + and - for three seconds does not lock or unlock the panel.
Your checklist / stored on this device

Press both pads at the same time for three seconds. LOC begins to flash.

Once LOC stops flashing the panel is locked.

Press and hold both pads for three seconds again; OPN flashes and then the panel is unlocked.

The guide carries a warning that the lock function leaves the oven door unlocked.

If repeated tries never lock or unlock the panel, book a technician.
Give us the model and the checks you have already done, and open your request from here.
Book a visit
Simplified drawing; the real layout depends on the model. Tap an outlined part to see its photo and the check that goes with it.
It is the icon the display shows for the control panel lock. LOC appears and flashes; the guide says the panel is locked once the flashing ends.
Read the supporting manualNo. The printed warning is explicit that this lock never locks the oven door, so do not count on it to keep children out of a hot oven.
Read the supporting manualThey are a pair. LOC appears when you lock, OPN when you unlock. Both come from the same + and - press.
Read the supporting manualManufacturer document
Kenmore
No edition printed / PDF p.16 (Electronic Oven Controls, Lock Controls)
Gas range 405.7608#, Electronic Oven Controls section, lock instructions on p. 16.
The guide states the lock controls function does not lock the oven door. LOC locks the control panel only.
Squeeze + and - together for three seconds. OPN appears and flashes, and the panel is unlocked once it stops.
The guide does not say. It describes the lock as a control panel feature, so check the oven state after you lock.
The guide does not say. If the pads feel dead after power returns, try the unlock press.
No. The guide describes LOC as the control panel lock, not a door-lock state.
Code, symptom, part or service
Hot appears on the 405.7608# gas range display when the oven is above 100 degrees F. A steam clean cannot start until the oven cools. It is a message, not an error.
On the Kenmore 790 ranges, a dead-looking oven panel usually means one of four things: the oven lockout is on, the clock was never set, an F or E code stopped the control, or power is missing. Cancel the lockout first; a code needs a restart.
Book a diagnostic for your model, carried out at the appliance.
Office details, and the access information to pass along.