Inside the appliance
Freezer temperature control. In plain English.
The temperature control sets how cold the freezer runs. On the 111.17142 chest freezer it is a dial on the lower front wall with five positions, 5 coldest and 3 recommended. On 253-series freezers it is a knob or an electronic control, and an alarm warns if the inside reaches an unsafe level.

Where it fits.
Freezer temperature control in the appliance
On the lower front exterior wall of a 111-series chest freezer, on the left exterior wall of other chest models, and inside an upright model.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Freezer temperature control concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore freezer does not run
When a Kenmore freezer does not run, the guide lists five causes: a GFCI-protected circuit, the temperature control in OFF, a loose plug, a blown fuse, a breaker that has tripped, and a power outage. The green Power light tells you whether the freezer has power.

Kenmore freezer too warm, too cold or running constantly
For a freezer that is too warm, the guide points to the control set too warm, a lid opened often, a lid not seating, a large warm load, or a recent disconnect. Turn the control and allow several hours. Cool-down is 4 hours on the chest freezers and 24 hours on the 253 series.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Check the position
The chest guide says OFF stops the freezer from running, while the power light stays on. Set it to 3 first.
- 2
Adjust in small steps
Turn toward 5 for colder or 1 for less cold, and give it several hours to level out between changes.
- 3
Allow the cool-down
The chest guide says 4 hours to cool completely. The 253 guide gives 4 hours in one place and 24 in another, so wait a day before judging.
- 4
Check for a mode
On a 253-series display, Express Chill makes the inside colder and Temp Alarm warns of unsafe temperature. Exit Express Chill from the options menu.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit when the freezer does not run with the control on, the plug tight and power confirmed.
Book a visit if the temperature stays too warm after a day at the right setting and normal door use.
Book a visit if the alarm sounds repeatedly with power on and the door shut.
Arrange a diagnosticSources and model boundaries.
These sources back up the Freezer temperature control guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore chest freezers 111.17142 / 111.17182
- Use & Care Guide, Kenmore 253-series freezers
Go by the instructions for your exact model. Check how we research these pages.
What setting should I use?
On the 111.17142 chest freezer, the recommended setting is position 3 on the 1 to 5 dial. Turn toward 5 for colder.
Why is the power light on with the control OFF?
The chest guide says the green Power light glows even when the control is turned to OFF. The Run light shows the compressor is running.
Why is the freezer too cold?
On a 253-series freezer, the guide lists Express Chill mode. Otherwise, turn the control to a warmer setting and let it stabilize.
How do I silence the Temp Alarm?
The 253 guide says press the set button next to ALARM OFF on the display, or any key on the control panel. The alarm needs household power to work.
Code, symptom, part or service
Link the message to what comes next.
Temp Alarm
Temp Alarm on a Kenmore 253-series freezer warns when the inside temperature reaches an unsafe level. It runs on household electricity and will not work during a power cut. Press the set button next to ALARM OFF, or any key, to silence it.
Kenmore freezer does not run
When a Kenmore freezer does not run, the guide lists five causes: a GFCI-protected circuit, the temperature control in OFF, a loose plug, a blown fuse, a breaker that has tripped, and a power outage. The green Power light tells you whether the freezer has power.
Freezer repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

