Inside the appliance
Freezer door and lid gasket. In plain English.
The gasket is a flexible seal that rings the freezer lid or door. Kenmore’s freezer guides name a dirty, worn, cracked or poorly fitted gasket as a reason the freezer runs too much, and tell you to clean or change it. A lid that does not seat can also cause moisture and a warm interior.

Where it fits.
Freezer door and lid gasket in the appliance
Around the edge of the lid on a chest freezer, or around the door opening on an upright model.
The picture shows the type of component. It does not pick out a replacement that fits your model.
What you notice when this system needs attention.
Freezer door and lid gasket concerns can show up together with weaker performance or a code that keeps returning. Testing is required before deciding whether the component is to blame.

Kenmore freezer does not run
When a Kenmore freezer does not run, the guide lists five causes: a GFCI-protected circuit, the temperature control in OFF, a loose plug, a blown fuse, a breaker that has tripped, and a power outage. The green Power light tells you whether the freezer has power.

Kenmore freezer too warm, too cold or running constantly
For a freezer that is too warm, the guide points to the control set too warm, a lid opened often, a lid not seating, a large warm load, or a recent disconnect. Turn the control and allow several hours. Cool-down is 4 hours on the chest freezers and 24 hours on the 253 series.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any owner check. Be careful around standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or go past what your model’s owner instructions allow.
- 1
Look at the whole seal
Check for dirt, cracks, tears and gaps along the full length of the gasket on the chest lid or upright door.
- 2
Clean it
The guides say to clean or change the gasket when it is dirty. Use the mild solution the guide gives for the inside and wipe the seal dry.
- 3
Check the level
On the chest freezers 111.17142 and 111.17182, an unlevel cabinet can force the lid out of square and misalign the seal. Level the freezer.
- 4
Close the lid fully
Nothing should hold the lid or door open, and loaded baskets should not sit on the edge of the seal.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit when the gasket is torn, cracked or hardened and you want it replaced.
Book a visit if frost builds up along the seal or the lid will not close after leveling.
Book a visit when the freezer runs constantly with a clean seal, correct setting and normal door use.
Arrange a diagnosticSources and model boundaries.
These sources back up the Freezer door and lid gasket guidance. Read the manual that fits your model.
- Use & Care Guide, Kenmore chest freezers 111.17142 / 111.17182
- Use & Care Guide, Kenmore 253-series freezers
Go by the instructions for your exact model. Check how we research these pages.
Does a worn gasket keep the freezer running?
Yes. The guides list a dirty, worn, cracked or poorly fitted gasket and say a leaking seal makes the freezer run longer to hold temperature.
What causes moisture on the outside of the freezer?
The chest guide says a lid that is not seating well lets cold air meet warm moist air from the room. Check the level and the seal.
How do I know the seal is leaking?
Frost near the lid edge and a freezer that runs long are signs. The guides do not give a test, so look along the seal for gaps.
Does leveling matter?
Yes. The chest guide says an unlevel freezer can push the cabinet out of square and misalign the lid and lid seal.
Code, symptom, part or service
Link the message to what comes next.
Kenmore freezer does not run
When a Kenmore freezer does not run, the guide lists five causes: a GFCI-protected circuit, the temperature control in OFF, a loose plug, a blown fuse, a breaker that has tripped, and a power outage. The green Power light tells you whether the freezer has power.
Freezer repair
Book a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, and the access information to pass along.

